Detaching piston from and attaching to connecting rod checking - changing connecting rod Detaching piston from and attaching to connecting rod Fig. 1 Remove piston with connecting rod. Clamp connecting rod in a vice using soft jaws. Remove gudgeon pin circlip. 1 Fig. 2 Push out gudgeon pin, holding piston in place. Take off and lay it aside. 2 Measure connecting rod big end bore (basic bore) Fig. 3 Insert new connecting rod bearing and fit cap. Tighten bolts to specified torque. Measure bearing bores with inside micrometer in measuring directions 1, 2 and 3 as well as in planes a and b. For max. perm. values, see “Engineering S Data S Setting values”.
Change connecting rods if deviations exceed the tolerance range. 1 8 mm 8 mm 2 b a 3 3 Fig. 4 Small end bushes are not available. If the bushes are worn, install reconditioned connecting rod. 4 140