Checking and adjusting start of fuel delivery Adjusting start of delivery If the check according to method a) or b) should prove that the delivery start is not correct, proceed as follows: Fig. 10 To adjust the start of delivery, the injection pump drive must be made accessible. For this purpose the fuel filter is to be removed (only in engine mod- els with box filters). Drain fuel from the filter car- tridges, loosen all fuel lines and completely remove filter with collector pan. 10 Fig. 11 Remove timing case cover. Note: Pipelines are attached to the timing case cover.
To facilitate reassembly, memorise or make a drawing or photograph of the positions of holders, pipe clamps, spacer sleeves etc. Loosen all bolts fastening the drive gear to the in- jection pump hub. For this, two complete turns of the engine are necessary. 11 Fig. 12 Turn engine to specified angle for delivery start. Remove screw plug from governor housing. The delivery start pointer must be visible in the centre of the inspection hole. Turn the injection pump camshaft on the drive flange to the left or right until the conditions men- tioned under a) or b) apply. Tighten bolts for fastening drive gear to drive flange consecutively to 5 Nm and then to 38 Nm. Note:
Use only M8x22 mounting bolts (property class 12.9). 12 Check delivery start once again. Close governor housing. 37