Removing and installing vibration damper, changing front crankshaft seal Removing vibration damper D Turn engine to ignition TDC. Cylinder 1 is at ignition TDC if the valves of the following cylin- ders are in crossover: - Cylinder no. 6 in 8-cylinder engines - Cylinder no. 7 in 10-cylinder engines - Cylinder no. 6 in 12-cylinder engines This ensures that in subsequent assembly work the indicating dial will be in the correct position. D Block the crankgear. D Relax and remove V-belt; see page 151 1 Fig. 1 Remove V-belt pulleys. Fig. 2 Remove delivery start indicator (picture shows ar- rangement of engine D 2840 LE 401) 2 Fig. 3 Loosen mounting bolts on vibration damper. Note:
Owing to the high tightening torque a rein- forced socket in conjunction with a 1/2” tool is required. 3 Fig. 4 Remove two bolts facing each other and replace them by two guide pins (M16 x 1,5). Remove all bolts. Remove vibration damper. Caution: The vibration damper is susceptible to shocks. Take hub and oil splash ring off the crankshaft. 4 79