Removing and installing vibration damper, changing front crankshaft seal Fig. 9 Pull off race. 9 Fig. 10 Special tools are required for installing the race (see page 169, item 15). Clean inner side of race and crankshaft stub. Coat crankshaft stub with sealing agent ”Antipor 46”. D Push race Ж and pressing sleeve З onto adapter В . D Tighten spindle А in adapter В with nut Г . D Bolt adapter В to crankshaft. 10 Fig. 11 The adapter must contact the crankshaft free of play so that the correct pressing depth for the race is ensured. Pull in race using collar nut and pressing plate ( И and Й in Fig. 10) until pressing sleeve З stops on the adapter. Note:
The bearing race can be installed even while the cover remains fitted. 11 Exchanging radial shaft seal Fig. 12 As spare parts the cover and shaft seal are deliv- ered only as a complete assembly in order to en- sure correct installation. To ensure that the shaft seal remains suitable for installation, it must remain on the transport and assembly sleeve until installed. 12 81