MAN — Removing and installing flywheel, replacing gear ring

Removing and installing flywheel, replacing gear ring Removing flywheel Fig. 1 Loosen mounting bolts (24 mm), securing the en- gine against turning if necessary. Note: Owing to the high initial torque a rein- forced socket (for machine screws) in con- nection with a 1/2” tool is required. 1 Fig. 2 Remove two bolts facing each other and replace them by two guide pins (special tool, see page 169, item. 16). Remove all bolts. 2 Fig. 3 Pull off flywheel using a flat metal bar and two bolts M12 x 1.5. Do not tilt it so that it jams. Danger: The flywheel is heavy. Use lifting gear. 3 Installing flywheel Fig. 4 Screw in guide mandrels (special tool, see page 169, item 16).

Apply sealing agent “Antipor 46” to the inside of the flywheel. Place guide mandrels on the flywheel, ensuring that the centering mandrel (arrow) fits correctly into the bore in the flywheel. Push on flywheel until it stops. 4 84