MAN — Removing and installing exhaust manifold with 8-hole-flange

Removing and installing exhaust manifold with 8-hole-flange Removing exhaust manifold D Drain coolant, see page 49 Fig. 1 Remove turbocharger (in LE4.. models complete with diffusor) (see page 99). Remove exhaust manifold (19 mm). Note: The picture shows an exhaust manifold with charge-air pressure control valve. 1 Fig. 2 Loosen mounting bolts (17 mm) and take off ex- haust manifold. To remove the right-hand exhaust pipe, the oil filter bowls must be removed (see page 71). Close up oil filter console to prevent dirt or foreign matter from getting into the lube oil circuit. Danger: The exhaust pipe is heavy. Replace two screws by stud bolts as a guide aid if necessary.

2 Remove exhaust manifold flanges. Installing exhaust manifold Fig. 3 To install the exhaust manifold flanges (8-hole flange), a dropped ring spanner (special tool, 19 mm) is required. Use dropped ring spanner only with torque wrench up to 200 Nm. Observe the order in which the bolts and nuts are to be tightened and the torque (see “Engineering, Data, Setting values”). Use new seals. 3 Fig. 4 The coolant inlet to the liquid-cooled exhaust pipes is located at the heat exchanger end. Ensure that the correct O-rings are used for the assembly. 4 92