1.14 FLYWHEEL 1.14.1 Flywheel Removal Removal steps are as follows: 1. Remove the transmission. 2. Remove the clutch from the flywheel. 3. Disconnect the electrical connector from the crankshaft position sensor and remove the sensor from the flywheel housing. See Figure 1-78. 1. Camshaft Position (CMP) Sensor 2. Crankshaft Position (CKP) Sensor Figure 1-78 Crankshaft Position Sensor 4. Remove the inspection cover from the flywheel housing and install the engine barring tool (J–46392). Insert the pin and make sure the tool is locked. Refer to section 1.17.2. All information subject to change without notice. 1-92 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION