Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.20 VALVES 9. Lubricate the valve stem and valve stem seal protector (J–46174) with a light coating of clean engine oil. 1. Valve Stem Seal 3. Valve Guide 2. Valve Stem 4. Valve Stem Sealing Ring (installed) Figure 1-135 Valve Stem Seal and Sealing Ring NOTE: The installer prevents the groove on the valve stem from damaging the valve stem seal. 10. Push the valve stem seal protector, (J–46174) over the valve stem until it makes contact with the valve. 11. Slide the valve stem seal over the valve stem seal protector, (J–46174) and onto the valve stem. Using fingers, press valve stem seal into place until the seal seats on the valve guide. 12. Remove the valve stem seal protector, (J–46174).

13. Using valve stem seal installer, (J-46184) and the appropriate hammer, drive the valve stem seal onto the guide. NOTE: Check the seal to make sure it is correctly seated on the valve guide. 14. Remove the installer (J-46184) from the valve stem seal and the valve. 15. Install the valve keepers, spring retainer, valve spring and spring base, as removed. 16. Repeat the procedure for the other valves. 17. Install the cylinder head on the engine. Refer to section 1.3.2. All information subject to change without notice. 1-152 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION