Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL Crankshaft Assembly The specifications for the torque of the main bearing-cap bolts is listed in Table 1-62. Crankshaft specifications are listed in Table 1-63. The dimensions for the center bearing shell and bearing journal are listed in Table 1-64. The crankshaft bearing journal dimensions are listed in Table 1-65. The main and connecting-rod bearing as well as the main bearing shell dimensions are listed in Table 1-66 and listed in Table 1-67. The torque values for the crankshaft counterweight bolts are listed in Table 1-68. Table 1-62 Tightening Stages, Main Bearing-Cap Bolts * Except as otherwise noted.

†Measure with the crankshaft mounted on the outer main bearing journals. ‡With the pin for the flywheel installed, but without the flywheel, and with the crankshaft mounted on the outer bearings. Table 1-63 Crankshaft Specifications Table 1-64 Bearing Shell and Bearing Journal Width All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-173 Max. Shaft Length:

mm (in.) Tightening Stage Torque N·m (lb·ft) 156.0 (6.14) Stage 1 100 (74) 156.0 (6.14) Stage 2 200 (148) 156.0 (6.14) Stage 3 300-330 (221-243) 156.0 (6.14) Stage 4 additional 90-100 degrees Description Specification mm (in.)* Main Bearing and Connecting Rod Journal Hardness (Rockwell hardness) 53 to 59 HRC Permissible Deviation From True of Crankshaft† 0.09 (0.004) Permissible Out-Of-Round for Main and Connecting-Rod Bearing Journals - When New or Reground 0.01 (0.0004) Permissible Out-Of-Round for Main and Connecting-Rod Bearing Journals - Wear Limit 0.02 (0.0008) Fillet Radii of Main Bearing and Connecting-Rod Bearing Journals 4.2-4.5 (0.165-0.177) Crown of Main Bearing Journals and Con- necting-Rod Journals 0.000-0.004 (0.0000-0.0002) Main Bearing Outside Diameter (diameter of bearing shell housing 111.000-111.022 (4.3701-4.3709) Permissible Imbalance of Crankshaft‡ -at 400 rpm 0.6 N·cm (0.05 lb·in) Size:

mm (in.) Center Bearing Shell Width mm (in) Center Bearing Journal Width mm (in.) Standard 45.74-45.81 (1.801-1.804) 46.000-46.062 (1.8110-1.8135) Undersize - 0.50 (0.020) 46.24-46.31 (1.820-1.823) 46.500-46.562 (1.8307-1.8331) Undersize - 1.00 (0.040) 46.74-46.81 (1.840-1.843) 47.000-47.062 (1.8504-1.8528)