2.6 FUEL INJECTOR 4. Remove the tensioning arm bolt. See Figure 2-21. 1. Short Leg 2. Long Leg Figure 2-22 Injector Removal Tool 5. Using the injector removal tool (J–47404) to remove the fuel injector from the cylinder head as follows: [a] Spread the jaws on the adaptor and position the adapter over the injector and secure in place with the sleeve ring. See Figure 2-23. [b] Install the base of the injector removal tool (J–47404) over the tool adapter. The long legs of the J-47404 should rest on the cylinder head, the short leg should rest on the rocker arm pedestal bolt. See Figure 2-22.
[c] Install the prying handle and nut on the tool adapter, then push down on the handle and remove the injector. If there is insufficient clearance to use the prying handle, use a wrench on the nut to remove the injector. NOTE: In cases where the injector removal tool (J–47404), with prying handle, cannot be used due to clearance, use a wrench on the nut to remove the injector. [d] Remove the tool from the injector. NOTE: Do not attempt to take apart the fuel injector. If there is a problem, replace the fuel injector. All information subject to change without notice. 2-34 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION