2.9 FUEL FILTER PERSONAL INJURY To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. 5. Remove the filter element from the cap and clean the fuel filter cap. Discard the filter element and the O-ring from the cap NOTE: Catch any fuel that runs out of the filter housing or fuel return line. 2.9.2 Installation of Fuel Filter Installation steps are as follows: 1. Lubricate the filter element rubber seal with a light coating of fuel oil and insert it into the filter housing. Push down and rotate the filter element while installing to ensure it is seated properly at the base of the housing. 2. Fill fuel filter housing with clean fuel oil. NOTE: Note:
A properly seated filter element will hold the fuel in the filter housing and prevent it from draining back to the tank. If the fuel does not stay in the housing the element is not seated properly, repeat steps 1 and 2. 3. Install a new O-ring on the filter cap and screw the cap onto the filter housing. Tighten the cap to 25 N·m (18 lb·ft). See Figure 2-31. 4. Work the fuel pump until resistance is felt. NOTE: There should be a strong resistance in the hand pump, caused by the pressure build-up within the fuel system. 5. Connect the batteries. 6. Crank the engine for 30 seconds at a time, but no longer. Before cranking the engine again, wait at least two minutes.
The engine should start within four 30-second attempts. All information subject to change without notice. 2-48 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION