EPA07 MBE 4000 SERVICE MANUAL 3.1 LUBRICATION SYSTEM DESCRIPTION The MBE 4000 engine features a full-flow filtered, pressurized lubricating oil system. The system incorporates various valves and restricted orifices to optimize the oil flow. External piping and plumbing is kept to a minimum to avoid oil leakage. The lubricating system consists of the following components: Oil pump Pressure regulator valve Pressure relief valve Oil filters and adaptor Oil cooler Oil level dipstick Oil pan Ventilation System An internal tooth gear pump is mounted to the bottom rear of the engine block and direct driven by the crankshaft at 1.06 times engine speed.
The location of the oil sump pick-up tube varies with oil pan choice. Oil leaving the pump is routed through the oil cooler, then to the oil filter and bypass valve. The oil is then routed into the main oil gallery in the cylinder block. From there, the oil is distributed to the crankshaft, rods, pistons and then to the camshaft bearings. Oil spray nozzles are installed in the block, which provide a continuous spray of oil to the underside of the pistons. From the cam bearings, oil is routed to oil passages in the cylinder head, which deliver oil to the valve train components and rocker arm pedestals.
A camshaft bearing galley supplies oil for spray nozzles, cam lobes, valve tappets, and the unit pumps. Drains from the head return oil to the pan. Oil for gear train components at the front of the engine is fed through drilled holes out of the main gallery. The turbochargers oil supply is taken from the oil galley circuit. Oil from the turbocharger returns to the crankcase via an external tube. An Electrostatic Oil Separator (EOS) pulls any oil droplets out of the crankcase vapor and returns the oil back into the oil pan. The clean air is then returned to the atmosphere. see Figure 3-1. All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3-3