Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1. Remove the oil fill-tube as follows: [a] Remove the bolt securing oil fill-tube to the mounting bracket. See Figure 3-27. [b] Unsnap the clamps securing the oil fill-tube to the cylinder block. See Figure 3-27. [c] Squeeze the clamp at the bottom of the oil fill-tube and pull from adaptor to remove the tube. [d] If necessary, remove the adaptor from the cylinder block. See Figure 3-27. [e] If necessary, remove the oil fill-tube mounting bracket by removing three bolts securing the bracket to the top of the EGR gas mixer housing. See Figure 3-27. 2. Remove the oil dipstick as follows: [a] Remove the dipstick from the dipstick tube.

[b] Remove two bolts and nuts securing two clamps on the oil dipstick to the mounting bracket. Remove the clamps from the oil dipstick. See Figure 3-27. [c] Remove bolt from the clamp securing the oil dipstick to the side of the cylinder block. Remove the clamp from the dipstick. See Figure 3-27. [d] Remove hose clamp at the bottom of the dipstick tube and pull tube from adaptor. See Figure 3-27. [e] If necessary, remove the oil dipstick adaptor from the oil pan. 3.9.2 Installation of Oil Fill-Tube and Oil Dipstick Installation steps are as follows: 1. Install the oil fill-tube as follows: [a] If removed, install oil fill-tube adaptor in the oil pan.

Torque the adaptor to 35 N·m (26 lb·ft) See Figure 3-27. [b] If removed, attach the oil fill-tube mounting bracket to the top of the EGR gas mixer housing and secure with three bolts. Torque the bolts to 30 N·m (22 lb·ft). See Figure 3-27. [c] Install the bottom of the oil fill-tube on the adaptor at the oil pan and snap in place. See Figure 3-27. [d] Install the oil fill-tube in the snap clamps and lock the clamps. See Figure 3-27. [e] Secure the oil fill-tube to the top of the mounting bracket with a bolt. Torque the bolts to 15 N·m (11 lb·ft). See Figure 3-27. 2. Install the oil dipstick as follows: [a] If removed install the oil dipstick adaptor in the oil pan.

Torque the adaptor to 50 N·m (37 lb·ft). See Figure 3-27. [b] Install the dipstick tube over the adaptor in the oil pan and secure with hose clamp. Tighten the clamp securely. See Figure 3-27. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3-35