EPA07 MBE 4000 SERVICE MANUAL 4.1.1 Draining and Flushing the Cooling System Drain and flush the cooling system as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Open the cap on the surge tank slowly, to allow excess pressure to escape. Set the cap aside. 2. Open the water regulating valve for the heating system. 3. Drain the coolant from the radiator. The cooling system capacity is listed in Table 4-1. * Does not include capacity of cooling system.
†With 1200 sq. in. radiator. Table 4-1 Cooling System Capacity All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 4-5 Description Capacity L (qts) Engine Coolant Capacity (all vehicles) Engine capacity* 30.0 (31.7) Century Class and Columbia Cooling System Capacity Total capacity† 57.4 (60.7) Antifreeze quantity at 50 percent 28.7 (30.3) Antifreeze quantity at 55 percent 31.6 (33.4) Sterling A-Line and L-Line Cooling System Capacity Total capacity 53.8 (56.8) Antifreeze quantity at 50 percent 26.9 (28.4) Antifreeze quantity at 55 percent 29.6 (31.3) FL112 Cooling System Capacity Total capacity 42.0 (44.4) Antifreeze quantity at 50 percent 21.0 (22.2) Antifreeze quantity at 55 percent 23.1 (24.4)