EPA07 MBE 4000 SERVICE MANUAL Coolant Pump The torque values for the cooling system are listed in Table 4-9. The wear dimensions for the coolant pump assembly are listed in Table 4-10. Listed in Table 4-11 is the critical dimension for the coolant pump assembly. Table 4-9 Cooling System Torque Values Table 4-10 Coolant Pump Assembly Wear Dimensions Table 4-11 Critical Dimension for Coolant Pump Assembly All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 4-37 Fastener Torque Nm (lb-ft) Coolant Pump Inlet Pipe Mounting Bolts 50 (37) Coolant Pump Mounting Bolts 30 (22) Coolant Pump Pulley Mounting Bolts 25 (18) Front Idler and Tensioner Support Mounting Bolts 60 (44) Thermostat Housing Mounting Bolts 25 (18) Description Dimensions, mm (in.) Drive Shaft Diameter (at the hub) 25.048 - 25.061 (0.9861 - 0.9867) Hub Inside Diameter 24.995 - 25.008 (0.9841 - 0.9846) Bearing Outside Diameter 54.981 - 54.994 (2.1646 - 2.1651) Bearing Housing Diameter 54.930 - 54.960 (2.1626 - 2.1638) Drive Shaft Diameter (at the impeller) 15.045 - 15.056 (0.5923 - 0.5928) Impeller Inside Diameter 15.000 - 15.018 (0.5906 - 0.5913) Impeller Outside Diameter 124 - 125 (4.88 - 4.92) Impeller - Maximum Out-of-Round 0.15 (0.0059) Description Dimensions mm (in.) Gap between the Impeller and the Coolant Pump Housing 0.6 - 1.0 (0.023 - 0.039)