Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 5.1 FUEL Detroit Diesel MBE 4000 engines for 2007 must be operated on Ultra-Low Sulfur Diesel (ULSD) fuel with 15 ppm sulfur content or less, based on ASTM D2622 test procedures. Grades such as marine diesel fuel, heating oil, and others are not acceptable and will cause the diesel particulate filter to prematurely plug with ash. Fuel additives are not required. Using fuel additives may affect your warranty. NOTICE: Fuel added from drums or cans could be contaminated. This could lead to malfunctions in the fuel system. Always filter the fuel before adding it to the tank. 5.1.1 Flow Improvers The effectiveness of flow improvers is not guaranteed with all fuels.

Comply with the product manufacturer's recommendations. Any authorized dealer can provide information on approved flow improvers. 5.1.2 Biodiesel Biodiesel fuels meeting ASTM D 6751 specification, prior to blending can be mixed up to 5% maximum by volume in petroleum diesel fuel. Detroit Diesel highly recommends biodiesel fuels made from soybean or rapeseed oil through the proper transesterification reaction process. Other feedstock source of biodiesel fuels such as animal fat and used cooking oils are not recommended by Detroit Diesel. The resulting mixture must meet ASTM D 975 specification.

More information is available in the Detroit Diesel publication Lubricating Oil, Fuel, and Filters (7SE270). Failures attributed to the use of biodiesel fuel will not be covered by Detroit Diesel product warranty. Also, any engine performance problem related to the use of biodiesel fuel would not be recognized nor considered Detroit Diesel's responsibility. 5.1.3 Used Lubricating Oil Do not use fuel blended with used lubricating oil. Detroit Diesel specifically prohibits the use of used lubricating oil in diesel fuel.

Used lubricating oil contains combustion acids and particulate materials which can severely erode fuel injector components, resulting in loss of power and increased exhaust emissions along with causing the diesel particulate filter to prematurely plug with ash. In addition, the use of drained lubricating oil will increase maintenance requirements due to filter plugging and combustion deposits. 5.1.4 Kerosene Do not use kerosene mixed in the fuel. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 5-3