Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

5.3 COOLANT NOTICE: containing new, fully-formulated antifreeze. This can cause deposits or dropout in the cooling system. The following types of corrosion inhibitors are approved for use in MBE 4000 engines: Supplemental Coolant Additives (SCAs) Nitrated Organic Acid Technology (NOAT) Inhibitors Corrosion inhibitors are very important in maintaining engine life. All corrosion inhibitors protect against corrosion caused by acid, and cavitation of wet cylinder liners. SCAs also protect against mineral deposits. The concentrations of some inhibitors will gradually diminish during normal engine operation.

To protect the engine, nitrite concentration must be checked at regular intervals, and inhibitors added as necessary. The intervals are longer if NOAT inhibitors are used. Always maintain inhibitor at the recommended level. Failure to properly maintain coolant with SCA can result in damage to the cooling system and related components. Over-concentration of SCA inhibitor can result in poor heating transfer and lead to engine damage. NOTICE: The following types of inhibitor must not be used in MBE 4000 engines: Soluble oil additives cause poor heat transfer and lead to engine damage.

Chromate additives can lead to the build-up of "green slime" (chromium dioxide) in the engine, leading to engine damage. 5.3.5.1 Dropout Excessive amounts of some corrosion inhibitors can cause a gel or crystalline deposit that reduces both heat transfer and coolant flow. This deposit is called "dropout." Dropout takes the color of the coolant when wet, but becomes a white or gray powder when dry. It can pick up solid particles in the coolant and become gritty. It will cause premature wear of the coolant pump seals and other components of the cooling system. The wet gel can be removed using an alkaline (non-acid) cleaner containing either sodium nitrite or sodium tetraborate.

If the gel is allowed to dry, it is necessary to disassemble the engine and clean it with a caustic solution, or physically clean the individual components. 5.3.6 Non-Approved Coolants The following types of coolant are not approved for use in MBE 4000 engines: All information subject to change without notice. 5-10 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION