EPA07 MBE 4000 SERVICE MANUAL 4. Check the turbine wheel and compressor wheel for damage to the blades caused by dirt, debris, and other foreign matter in the turbocharger air system. See Figure 6-14 for the turbine wheel and compressor wheel. 1. Blade 3. Rotor Shaft 2. Turbine Housing 4. Compressor Housing Figure 6-14 Turbine Wheel and Compressor Wheel [a] If wheel blades are worn at the leading edges, ripped, cut, or bent backwards, replace the turbocharger. Refer to section 6.7.2. [b] Clean the exhaust manifold and the entire turbocharger air system. 5. Check the turning smoothness and uniformity of the rotor shaft.
[a] Turn the shaft alternately, in both clockwise and counterclockwise directions, until it is clear of carbonized oil. [b] Turn the nut on the end of the rotor shaft. Check that the shaft does not bind in some places and spin in others (smoothness). [c] Turn the nut on the end of the rotor shaft. Check that the same amount of turn on the nut always causes the same amount of turn on each wheel (uniformity). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 6-27