6.8 WASTEGATE ACTUATOR 11. Install replacement E-clip onto the wastegate lever pin. 12. Tighten the jam nut on the wastegate actuator adjusting rod, taking care not to rotate the actuator shaft. Torque jam nut to 5 N·m (4 lb·ft). 13. Disconnect regulated air supply. 14. Install the turbocharger. Refer to section 6.7.3. 15. Verify the repair. All information subject to change without notice. 6-40 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION