7.1 EXHAUST MANIFOLD ASSEMBLY 1. Exhaust Manifold Gaskets (qty 3) 6. V-Band Clamp 2. Exhaust Manifold End Piece 7. Adaptor 3. Exhaust Manifold Center Piece 8. Bolt (qty 12) 4. Bellows 9. Spacer (qty 12) 5. Sleeve Figure 7-2 Exhaust Manifold Assembly and Components (View 2) 7.1.1 Removal of Exhaust Manifold Removal steps are as follows: NOTE: The EGR cooler and cooler bracket remain installed on the engine when the exhaust manifold assembly is removed. 1. Remove the turbocharger. Refer to section 6.7.2. 2. Remove the EGR gas inlet pipe. Refer to section 8.1.1. 3. Remove the three bolts attaching the lower heat shield to the bottom of the exhaust manifold. See Figure 7-3. 4.
Remove the two bolts attaching the lower heat shield to the upper heat shield. Remove the lower heat shield. All information subject to change without notice. 7-4 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION