10.2 REAR ENGINE POWER TAKE-OFF 10.2.1 Inspection of Torsional Coupling NOTE: The torsional coupling must be replaced during normal engine overhaul, contact the Customer Support Center for further details. Inspection steps are as follows: 1. Visually inspect the outer case of the torsional coupling for dents and bulges. [a] If damage was detected, replace the with a new torsional coupling. [b] If no damage was detected, reuse the torsional coupling and go to step 2. 2. Inspect the rubber element of the torsional coupling for bulges and cracking. [a] If damage was detected, replace with a new torsional coupling. [b] If no damage was detected, reuse the torsional coupling and go to step 3. 3.
Inspect the rubber element teeth for wear. See Figure 10-7. 1. Rubber Element Teeth 2. Torsional Coupling Casing Figure 10-7 Torsional Coupling [a] If the rubber element teeth are worn less than one-half of the original length 11.0 mm (0.433 in.), replace with a new torsional coupling. [b] If no damage was detected, reuse the torsional coupling. All information subject to change without notice. 10-8 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION