Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 11.2.1.1 Inspection of Air Compressor Inspection steps are as follows: 1. Inspect the O-rings on the fittings at the air system ports and replace if necessary. If the O-rings are damaged, replace the fittings also. 2. Replace the O-ring between the power steering pump and the air compressor. 3. Install the locking device (J–46177) on the driveshaft end of the air compressor. This locks the driveshaft to allow removal of the drive nut. 4. Remove the drive gear from the air compressor. [a] Place the air compressor and locking device (J–46177) in a vise. Make sure the locking device is tightly secured and cannot slip or slide out of the vise.

[b] Using an impact wrench, remove the drive nut from the drive gear. [c] Remove the locking device (J–46177) from the air compressor and the vise. [d] Remove the drive gear from the air compressor with a gear puller, if necessary. [e] Discard the O-ring on the driveshaft end of the air compressor. 5. Inspect the drive gear for worn or broken teeth, spalling, and corrosion. Replace the drive gear if necessary. 6. Install the drive gear, drive nut, and a new O-ring on the driveshaft end of the air compressor. Tighten the drive nut 290 N·m (214 lb·ft). See Figure 11-6. 1. Air Compressor 3. Drive Gear 2. O-ring 4. Drive Nut Figure 11-6 Air Compressor Drive Gear 7.

Release the air compressor from the vise. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 11-9