EPA07 MBE 4000 SERVICE MANUAL 12.1 PREPARATION FOR A FIRST TIME START NOTE: Before starting the engine, do all the recommended pretrip inspections and daily maintenance. Check the engine oil and fuel levels, and drain contaminants from the fuel/water separator (optional). NOTE: If you drain the fuel/water separator completely, you may have to prime the fuel system. Read the appropriate chapters in the driver's manual for detailed information on instruments, gauges, and controls. Be sure you are familiar with all of the instruments, gauges and controls which are needed to operate the engine. Note especially the location and function of the following:
Oil pressure gauge Low oil pressure warning light Coolant temperature gauge High coolant temperature warning light Water in fuel warning light Tachometer Air restriction indicator When you start the engine, and while you are driving, watch for any signs of engine problems. If the engine overheats, uses excessive fuel or lubricating oil, vibrates, misfires, makes unusual noises, or shows an unusual loss of power, turn the engine off as soon as possible and determine the cause of the problem. Frequently, engine damage may be avoided by a quick response to early indications of problems. 12.1.1 Checking the Batteries Use only batteries that have been correctly filled and serviced.
To provide corrosion protection, apply pumpable dielectric grease, part number 48-02349-000, liberally to the terminal pads. Approved suppliers are listed in Table 12-1. Table 12-1 Approved Electrical Lubricants All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 12-3 Manufacturer Lubricant or Part Number Shell Oil Co. No. 71032; No. 71306 Texaco, Inc. No. 955 Quaker State No. NYK-77