Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 12.1.3 Checking the Coolant Level (Cold Check) Check coolant level as follows: 1. Ensure that all coolant plugs in the bottom of the radiator and on the radiator outlet pipe are secure and tight. 2. Check the coolant level. The cooling system is correctly filled when the coolant is between the maximum and minimum marks on the surge tank. 12.1.4 Adding Fuel When adding fuel, pay attention to the following: Add winter or summer grade fuel according to the season of the year. Refer to publication Engine Requirements – Lubricating Oil, Fuel and Filters , (7SE270), available from authorized Detroit Diesel distributors. Work in the cleanest conditions possible.

Prevent water from entering the fuel tank. 12.1.5 Priming the Fuel System Prime the fuel system as follows: NOTICE: Correct torque on the high-pressure lines is critical. Incorrect torques could result in leaks or lack of power due to restricted fuel flow. 1. Make sure that all high-pressure lines have been tightened to 35–37 N·m (26–27 lb·ft) and all banjo bolts to 45-50 N·m (33-37 lb·ft). ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. 2. If equipped with a hand pump on the fuel/water separator, work the hand pump until resistance is felt. All information subject to change without notice.

DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 12-5