Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4. Remove the two bolts from the rear engine lifting bracket and remove the bracket. See Figure 1-38. 1. Clamp (EGR Cooler Gas Inlet Pipe) 5. Bolt and Nut (Air Compressor Coolant Line) 2. Bolts (Gas Inlet Pipe Mounting Bracket) 6. Bolt 3. Mounting Bracket (EGR Cooler Gas Inlet Pipe) 7. Clamp (Crankcase Breather Tube) 4. Rear Engine Lifting Bracket Mounting Bolts 8. Rear Engine Lifting Bracket Figure 1-38 Rear Engine Lifting Bracket 1.5.2 Installation of Front and Rear Engine Lifting Brackets Installation steps are as follows: 1. Install the front engine lifting bracket using the four mounting bolts. See Figure 1-37. 2. Torque the four bolts to 60 N·m (44 lb·ft).

3. Install the rear engine lifting bracket using two mounting bolts. Torque the two bolts to 200 N·m (148 lb·ft). See Figure 1-38. 4. Install the bolt securing the air compressor coolant line bracket to the rear lifting bracket. Torque the bolt to 30 N·m (22 lb·ft). See Figure 1-38. 5. Install the bolt securing the crankcase vent pipe bracket to the rear lifting bracket. Torque the bolt to 50 N·m (37 lb·ft). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-43