Yamaha Motor Corporation, USA 115A/130A/L130A/150A/V150A — BASIC COMPONENTS

E 2) Align the three cowling hooks with the locks on the bottom cowling. 3) Press down on the top of the cowling at the front and both sides of the back until the three locks click. 4) To make sure the cowling is locked properly push the cowling from each side. If it lifts, repeat step 3. V4 211013 Make sure the cowling lock connection cable is operating correctly before rein- stalling the top cowling. 8 When the release lever is operated, both front and rear cowling hooks should be released at the same time. If not, adjust the cable adjuster for the rear clamps. 8 Make sure the cable operates smooth- ly and is free of corrosion. 8 Check that the cable is properly secured in the holder.

8 When reinstalling the cowling, insure that both the front and rear locks have operated properly. If the cowling has not been locked prop- erly some parts may be damaged by the top cowling shaking during operation. c C EMU01146 FLUSHING DEVICE This device 1 is used to clean the cooling water passages of the motor using a gar- den hose and tap water. NOTE: Refer to “Cleaning Cooling-water Pas- sages” in Chapter 4 for instructions on usage. q 000825 2-22