E ADJUSTING TRIM ANGLE UP EMU01401 Power Trim/Tilt Model q w 8 Be sure all people are clear of the out- board motor when adjusting the trim/tilt angle, also be careful not to pinch any body parts between the drive unit and clamp bracket. 8 Use caution when trying a trim position for the first time. Increase speed gradu- ally and watch for any signs of instabili- ty or control problems. 8 Use the power trim/tilt switch located on the bottom engine cowling (if equipped) only when the boat is at a complete stop with the engine off. DN 702014* q DOWN UP 702042* The outboard motor trim angle can be adjusted operating the power trim/tilt switch 1 .
To raise the bow (“trim-out”), push the switch UP. To lower the bow (“trim-in”), push the switch DN. Make test runs with the trim set to differ- ent angles to find the position that works best for your boat and operating condi- tions. NOTE: To adjust the trim angle while the boat is moving, use the power trim and tilt switch located on the remote control device or tiller handle, if so equipped. 3-19