Yamaha Motor Corporation, USA 115A/130A/L130A/150A/V150A — OPERATION

E 4) Once the engine is supported with the tilt-support lever, push the power trim/tilt switch DOWN to retract the trim rods. c C Be sure to retract the trim rods complete- ly during mooring. This protects the rods from marine growths and corrosion which could damage the power trim/tilt mechanism. 411014 PROCEDURE FOR TILTING DOWN Power trim and tilt 1) Push the power trim and tilt switch “UP” until the engine is supported by the tilt rod. 2) Release the tilt-support lever. 3) Push the power trim and tilt switch “DN” (Down) to lower the engine to the desired position.

411021 EMH60010 CRUISING IN OTHER CONDITIONS CRUISING IN SALT WATER After operating in salt water, wash out the cooling-water passages with fresh water to prevent them from becoming clogged- up with salt deposits. NOTE: Refer to cooling system flushing instruc- tions in STORING AND TRANSPORTING OUTBOARD MOTOR. CRUISING IN TURBID WATER It is strongly recommended that the optional chromium-plated water-pump kit be installed if the outboard is to be used in turbid (muddy) water conditions. 3-24