Yamaha Motor Corporation, USA 115A/130A/L130A/150A/V150A — MAINTENANCE

E [How to remove propeller] 1) Using the pliers provided, straighten the cotter-pin and pull it out. 2) Remove the propeller nut. 3) Remove the propeller. 6 3 45 1 2 1 Thrust washer 4 Washer 2 Propeller 5 Propeller nut 3 Spacer 6 Cotter pin 602041 [How to install propeller] 1) Apply Yamaha Marine grease A or Marine grease (water-resistant grease) to the propeller-shaft. 2) Slide the propeller over the propeller- shaft. c C Be sure to install the thrust washer before installing propeller, otherwise, lower case and propeller boss may be damaged. 3) Tighten the propeller nut to the specified torque. Tightening torque: Refer to “SPECIFICATIONS”, Page 4-1.

4) Align the propeller nut with the propeller shaft hole. Insert a new cotter pin in the hole and bend the cotter pin ends. NOTE: When the propeller nut does not align with the propeller shaft hole after tightening to the specified torque, then tighten it more to align the hole. c C Be sure to use a new cotter pin and bend the ends over securely. Otherwise, the propeller could come off during opera- tion and be lost. 602053 4-22