Operating & maintenance manual 21.5 Maintenance work referring to the electrical system 21.5.1 Maintenance work related to the battery 2 Check the battery poles ( 2 ) for the accumulation of dirt and for signs of corrosion. Lubricate the poles and terminals. Grease: order no. 0830684. Fig. 128 Battery 21.5.2 Printed circuit board, fuses and relays Check the printed circuit board, the fuses and relays on the printed circuit board. The printed circuit board is installed next to the driver’s seat (on the left) and is covered by a faceplate. Open the faceplate ( 3 ) covering the printed circuit board ( 4 ) and check the printed circuit board by conducting a visual inspection.
Check all fuses and relays, particularly fuses F24 ( 5 ), F25 ( 6 ), F26 ( 7 ) and relays K14 ( 8 ) and K16 ( 9 ), for the accumulation of dirt and damage. Always replace defective fuses by new ones, see Maintenance instructions for the service staff . 9 8 5 6 7 3 Fig. 129 Printed circuit board Fuses and relays in the engine compartment: Check fuses F17 ( 10 ), F100 ( 11 ) and relay K09 (12 ) in the engine compartment for the accumulation of dirt and damage. Always replace defective fuses, see table below for the allocation of the fuses on the printed circuit board. 12 10 11 Fig. 130 Fuses and relays 103 WARNING Risk of explosions and injuries Battery gases are highly explosive.
Keep away sparks and open fire from the battery. Do not smoke. Avoid all skin contact with battery acid, as it may lead to severe chemical burns! Protect your eyes and your skin!