Operating & maintenance manual 23 Initial operation 23.1 Delivery receipt of the compaction roller Ƒ Ascertain the completeness of the delivery (including all accessories and the technical documentation). Ƒ Make a note of any damage found. Ƒ Refer to the chapter Note of delivery and verification of inspections for information on the default maintenance intervals (maintenance certificates). 23.1.1 Checking the operating state of the compaction roller x Check the following fill levels: Ensure that the following fill levels correspond to the required levels (see Technical Specifications ):
Ƒ Engine oil level Ƒ Coolant level Ƒ Hydraulic oil level Ƒ Oil level in the drum drive Ƒ Oil level in the vibration drive Ƒ Check the Diesel / AdBlue ® / DEF levels Ƒ Check the water level for the washing water pump Ƒ Check (correct) the tire inflation pressure Ƒ Screw connections: Ƒ Tighten the wheel nuts by means of a torque key (tightening torque: 500 Nm ). Ƒ Check all screw connections. x Check the hydraulic system Ƒ Check the hydraulic hoses and screw connections for signs of leakage. 108 NOTICE x Make sure all checks and maintenance measures required for the initial operation are carried out in the presence of the customer or his/her staff. x Obtain a written confirmation.
NOTICE Inform the customer and his/her staff of the warranty terms as provided in the contract. As for the liability of the manufacturer, refer to the corresponding section in the operating and maintenance manual. NOTICE x Make sure all checks and maintenance measures required for the initial operation are carried out in the presence of the customer or his/her staff. x Obtain a written confirmation. x Indicate the respective chapters in this manual.