hyundai — AW1110-AW1140 EN 05 20 1.0

Operating & maintenance manual 21.1.4 Topping up on engine oil Add a sufficient quantity of engine oil (approx. 12 liters/4 gallons) via the filler neck ( 2 ). After filling in the engine oil, screw off the lid and let the Diesel engine turn via the starter. Check the oil level at the oil dipstick and add oil, if necessary. Start the Diesel engine and let it idle to reach operating temperature. 2 Fig. 116 Adding engine oil 21.1.5 Cooling system To be carried out if the warning lamp lights up or after repair work: x Check the coolant level. x Open the cover ( 3 ) with the ventilation grills (right, in the direction of motion). x Carefully screw off the lid ( 2 ) of the combination cooler.

x Check the coolant level. x If coolant needs to be added or after repair work, the following mixing ratio is required: x Capacity of the cooling system: approx. 15 liters (4 gallons). x Mixing ratio: 0.6 liter (20 oz.) of water and 0.4 liter (13.5 oz) of coolant per liter (i.e. water: 60% / coolant: 40%) 2 3 Fig. 117 Coolant level 96 SAFETY Refer to the table of lubricants for specifications of the oil to be used. INSTRUCTIONS NOTICE Environmental protection! The engine oil must not penetrate the ground, pollute water or leak into the sewer system. Be sure to collect the engine oil in sufficiently dimensioned receptacles and dispose of it in an environmentally friendly way.

WARNING Risk of burns caused by hot coolant Before you open the lid of the cooler, make sure that the Diesel engine and the cooling system have cooled down.