hyundai — AW1110-AW1140 EN 05 20 1.0

Operating & maintenance manual 21.2.3 Hydraulic oil change Replace the hydraulic oil at intervals of 2000 operating hours or if another type of oil is to be used. Start the Diesel engine and let it run until the hydraulic oil has warmed up. Stop the Diesel engine and pull out the ignition key. Place an oil receptacle under the hydraulic tank. Unscrew the filler neck with the oil dipstick ( 1 ). Unscrew the oil drain plug, remove the oil dipstick and drain the hydraulic oil. Dispose of the waste oil in an environmentally friendly way. Replace the oil filter cartridge, see description above. Screw in the oil drain plug with a new O-ring. Add hydraulic oil via the filler neck.

Start the Diesel engine and let it run until the hydraulic oil has warmed up. Stop the Diesel engine and pull out the ignition key. Check the hydraulic oil level again. 1 99 Fig. 122 Hydraulic oil NOTICE • T • T c • B • I r ake the compaction roller to a workshop in order to carry out the oil change. ake the amount of hydraulic oil to be drained into account and be sure to hoose a sufficiently dimensioned oil receptacle. e sure to exercise extreme cleanliness when filling in hydraulic oil! nform yourself of the type of hydraulic oil in the hydraulic system. Please efer to the Table of lubricants for the required specifications.

En NOTICE • T s • C e vironmental protection he engine oil must not penetrate the ground, pollute water or leak into the ewer system. ollect it in sufficiently dimensioned receptacles and dispose of it in an nvironmentally friendly way.