DISASSEMBLY AND ASSEMBLY OVERALL ASSEMBLY 5) Rocker arm assembly a) Install rocker arm assembly (2). b) Check that ball of adjustment screw is fitted securely in socket of push rod, and tighten mounting bolts in turn. - Rocker arm mounting bolt: 25.0 2 4.9 Nrn 12.5 2 0.5 kgrn} * Turn back the adjustment screw 3 - 4 turns. 16. Adjustment of valve clearance Adjust the valve clearance so that the clearance between the valve and rocker arm is the follow- ing value. * Standard value for valve clearance (both when warm and when cold) Intake valve: 0.35 mm; Exhaust valve: 0.50 mm 1) Rotate the crankshaft in the normal direc- tion to align pointer b with the 1.4 TOP mark a on crankshaft pulley (I).
When rotating, check the movement of the intake valves of No. 4 cylinder. 2) With No. 1 cylinder at compression top dead center, adjust valves marked 0 in valve ar- rangement diagram. Then rotate crankshaft a further 360" and adjust valves marked 0. I V a l v e a r r a n g e m e n t 3) To adjust, insert feeler gauge @ between rocker lever and valve stem, turn adjustment screw until clearance is a sliding fit, then tighten locknut. - Locknut: 44.0 2 4.9 Nm 14.5 2 0.5 kgrn} 4) It is also possible to set the No. 1 cylinder to compression top dead center and adjust the valves of the No.
1 cylinder, then rotate 180" each time and adjust the valve clearance of the other cylinders according to firing order. Firing order: 1 - 2 - 4 - 3 I TDP00308 1 3-26 95-2 SERIES