MAINTENANCE STANDARD CAMSHAFT CAMSHAFT (Bushing installed to journal No. 2 and 3) TDC 0 0 v e v a I v e I n t a k e v a l v e BDC 5. V a l v e t i m i n e SXE01339 Unit: m m Check item Remedy Standard size Repair limit End play 0.150 - 0.350 0.5 Replace thrust plate Journal Standard Tolerance Standard Clearance Outside diameter of size Shaft Hole clearance limit camshaft bearing journal ~ ~ . l No.2 -0.080 +0.030 0.040 50.5 -0.110 -0.040 - 0.140 0.25 Replace bushing Curvature of camshaft Repair limit:
0.03 (Total deflection of indicator) Standard size I Tolerance ReDair limit Replace Height of camshaft Intake 42.69 42.2 kO.10 43.04 42.5 Exhaust Va Ive position When testing (Crankshaft angle when valve has gone . down 1 mm) angle Standard Tolerancc Intake open Before TDC 9" Before TDC 8" Check for curvature or wear of valve, camshaft, push rod. Correct or replace Valve timing Intake closed Exhaust open After BDC 20" After BDC 4" k3O Before BDC 60" Before BDC 45" Exhaust closed After TDC 12" After TDC go 14-8 95-2 SERIES