REPAIR AND REPLACEMENT OF PARTS REPLACING CAMSHAFT BUSHING * Cam bushing assembly drawing 2) After removing the bushing, remove any burrs or dirt from the mounting hole of the bushing. Notch M h o l e Bush i n a I HXE00371 3. Press fitting center bushings Assemble bushing (6) to tool A and press fit the bushing until the oil hole in cylinder block (5) is aligned with the oil hole in the bushing. SWE01287 4. Press fitting front and rear bushings Assemble bushing (6) to tool A, and press fit the bushing until the oil hole in cylinder clock (5) is aligned with the oil hole of the bushing. 5 1 3 2 1 c SWE01288 5.
After press fitting bushings 1) Using inside gauge a, measure the inside diameter of the bushing. 2) Check the clearance between the bushing and shaft, and if the clearance is not within the specified range, or the shaft does not pass through smoothly, correct the inside diameter of the bushing with a reamer. A When correcting the inside diameter of the bushing with a reamer, clean all chips from the oil hole and oil groove. * Inside diameter of cam bushing: * Clearance of camshaft journal: 050.5 ::$: mm 5 SWE01289 0.030 - 0.130 mm 1 5-6 95-2 SERIES