Komatsu 95-2 DIESEL ENGINE — PROCEDURE FOR PRESSURE TEST

REPAIR AND REPLACEMENT OF PARTS PROCEDURE FOR PRESSURE TEST PROCEDURE FOR PRESSURE TEST When corrections have been made around the cylinder head, test the pressure as follows. Special tools No. Q’ty A 1 B 1 1. Water pressure test 1) Tighten the nozzle holder assembly to the specified torque. 2) Assemble tool A and tool B , and connect the hose to flange (1). 3) Apply water pressure 0.25 – 0.6 MPa {2.5 – 6.0 kg/cm 2 } for approx. 10 minutes, and check that there is no leakage from around the head. fl When carrying out this test, heat the whole cylinder head and carry out the test with hot water (82 – 93°C). 2. Air pressure test 1) Tighten the nozzle holder assembly to the specified torque.

2) Connect the compressor hose to flange (1). 3) Put the head in the container of water, apply air pressure 0.2 MPa {2.0 kg/cm 2 } for approx. 30 seconds, and check that there is no leak- age in the water. fl If the above test shows any cracks in the nozzle holder or around the plate plugs, replace the cylinder head. fl If cracks are found in any other places, weld to repair. 95-2 SERIES 15-10 15-10 1 Part No. Part Name 790-513-4200 Coolant test kit 79A-471-1050 Pump assembly