Komatsu 95-2 DIESEL ENGINE — GRINDING CRANKSHAFT

REPAIR AND REPLACEMENT OF PARTS GRINDING CRANKSHAFT GRINDING CRANKSHAFT Applicable crankshaft It is possible to correct by grinding and rebuild so that undersize bearings can be used only with crankshafts which have received induction hardening. This method of repair may not be used for crank- shafts that have received tufftride treatment. ( * 1) It is possible to distinguish these two types of crankshaft from the engine serial number ( * 2), but check the crankshaft as follows to ensure that there is no mistake.

( * 1) With tufftride treatment, the hardened layer is thin, so if additional grinding is carried out, the hardened layer will be removed and it will be impossible to ensure the strength and wear resistance. ( * 2) The part number does not change when there is change in the surface treatment of the crankshaft, but as shown above, the crankshaft pin bearing is changed at the same time. 95-2 SERIES 15-14 15-14 1