Komatsu 95-2 DIESEL ENGINE — ENGINE CUT SOLENOID

STRUCTURE AND FUNCTION FUEL SYSTEM FUEL CUT SOLENOID B CONTACT SYSTEM (CONSTANT CURRENT) 1. Case 2. Return spring 3. Internal wiring diagram 3A. C1 Attraction coil 3B. C2 Holding coil 4. Stop lever 5. Fuel control lever 6. Solenoid Specifications Solenoid Type: Synchrostart drip-proof type Rated voltage: DC24V Actuating current: When starting to pull: Approx. 25 A When finishing pulling: 0.5 A Stroke: 25.4 mm Weight: 1 kg When the engine started, electricity passes through the solenoid and the solenoid plunger is actuated. This extends return spring (2) (built into the solenoid) and pulls it to the engine run position, and holds it in position.

When stopping the engine, the key is turned to the STOP position and the flow of current through the solenoid is stopped. The mag- netic force of the solenoid disappears, so the force of the return spring moves the in- jection pump stop lever to the engine STOP position (no injection). The solenoid plunger is also pulled back at the same time, and the engine stops. The fuel injection amount is controlled by fuel control lever (4) when the engine is run- ning. Adjust length of rod when installing the fuel solenoid valve (see TESTING AND ADJUST- ING). 95-2 SERIES 11-30 1