TESTING AND ADJUSTING MEASURING COMPRESSION PRESSURE MEASURING COMPRESSION PRESSURE MEASUREMENT PROCEDURE A While measuring the compression pressure, take care not burn yourself on the exhaust manifold or muffler, and be careful not to get caught in any revolving part of the engine. Measure the compression pressure while the engine is warm. (Oil temperature: 40 - 60°C) * 1. Adjust the valve clearance properly. For details, see ADJUSTING VALVE CLEARANCE. 2. Remove spill tube and disconnect fuel injection pipe. 3. For machines with a key stop system, remove the wiring of the fuel cut solenoid. (For machines with a stop motor installed, re- move the wiring of the connector.) 4.
Remove nozzle holder assembly for each cylin- der. * Remove the nozzle holder assembly by pry- ing it with the spill tube mounting bolt. * Take care not to let any dirt or foreign mat- ter get into the cylinder. * When the nozzle holder assembly is re- moved, replace the seat gasket. 5. Install adapter A to the nozzle holder mounting section of the cylinder to be measured, and tighten the adapter to the specified torque. Torque: 44 2 5 Nm (4.5 2 0.5 kgm} 6. Connect compression gauge A to the adapter. 7. Place the fuel control lever in NO INJECTION position, crank the engine with the starting mo- tor, and read the gauge when the pointer is stabilized.
A If you do not put the fuel control lever in NO INJECTION position, fuel will blow out. * Most compression leakage can be prevented by applying a small amount of oil to the mounting section of the adapter. * For the reference values of the compression pressure, see TESTING AND ADJUSTING DATA. 1 2-4 95-2 SERIES