Komatsu 95-2 DIESEL ENGINE — TESTING AND ADJUSTING FUEL INJECTION TIMING

TESTING AND ADJUSTING TESTING AND ADJUSTING FUEL INJECTION TIMING TESTING AND ADJUSTING FUEL INJECTION TIMING Counter mark method * Adjustment is normally carried out using this method. (In cases when the fuel injection pump has not been repaired and is assembled again to the same engine, or when only the fuel injection timing is checked) 1. Set the No. 1 cylinder to the compression top dead center. 1) Rotate the crankshaft in the normal direc- tion and align pointer (2) with (1.4 TOP line) (1) on the crankshaft pulley. 2) Use the procedures below to check that the No. 1 cylinder is at compression top dead center. If the condition is not as shown be- low, rotate the crankshaft one more turn.

* When fuel injection pump has been re- moved: Check that it is possible to see the C at the tip of the idler gear teeth. * When fuel injection pump is installed to engine: Remove the head cover and check that the intake and exhaust valves of the No. 1 cylinder are closed (there is a clearance for both the No. 1 intake and exhaust valves). BWP04015 2. Remove cover (3) at the front of the fuel injec- tion pump. 3. Install to the engine with the fuel injection pump holder and drive gear as one unit. 4. Insert the timing check pin (diameter: 4 - 4.5 mm, length: 80 mm) through hole a in the front gear cover and align with the hole in the drive gear. * The timing check pin must enter straight.

Check that the hole in the fuel injection pump holder is aligned with the mounting hole in the front gear cover (the mounting bolt goes in). * If the position is not aligned, remove the fuel injection pump again and check the meshing of the drive gear. 5. Remove the timing check pin and tighten all bolts. 1 2-6 95-2 SERIES