TESTING AND ADJUSTING TROUBLESHOOTING POINTS TO REMEMBER WHEN TROUBLESHOOTING Troubleshooting means locating the basic cause of the failure, and carrying out swift repairs, and ensuring that the failure does not occur again. When carrying out troubleshooting, it is of course important to understand the structure and function. But to carry out the troubleshooting effectively, a quick method is to carry out troubleshooting using the problems mentioned by the operator as a guide in locating the cause. 1. Do not disassemble the machine simply because there is a failure If the machine is disassembled immediately just because there is a failure: 0 Unrelated or unnecessary places are also 4.
Confirming failure Check the degree of the problem to judge for yourself if it is really a failure, or if there is some problem in the handling or opera- tion of the machine. * When driving the machine and re-enact- ing the failure, be sure that the investi- gation or measurement does not make the failure worse. disassembled 0 It becomes difficult to locate the cause This means that there is not only a waste of time and money on replacement parts, oil, and grease, but this action will also lose the confidence of the user and operator.
For this reason also, it is important to carry out troubleshooting based on full investiga- tion before starting and troubleshooting fol- lowing before the correct order. of the failure 5. Troubleshooting Narrow down the cause of the failure from the results of the questions and checks in the above Items 2 - 4, then follow the trou- bleshooting flow charts to locate the failure. * Basic procedure for troubleshooting 1) Start from the simple places. 2) Start from the most probable places. 3) Investigate related parts also. 2. Questions to ask the user and operator 1) Are there any problems other than those already reported? 2) Did anything unusual happen before the failure occurred?
3) Did the failure occur suddenly, or had the condition of the machine been poor before the failure occurred? 4) What were the conditions when the fail- ure occurred? 5) Had any repairs been carried out before the failure occurred? 6) Had any similar failure occurred before? 6. Basic action to remedy cause of failure Even if the failure is repaired, if the root cause of the failure is not repaired, the same failure will occur again. To prevent this, it is necessary to investigate why the failure occurred, and to remove the root cause of the failure. 3. Check before troubleshooting 1) Check the oil level. 2) Check for any external leakage of oil from the piping and hydraulic equipment.
3) Check the travel of the control levers. 4) Other maintenance items can also be car- ried out visually, so carry out any check that is considered necessary. 12-1 06 95-2 SERIES