TROUBLESHOOTING, TESTING AND ADJUSTMENT Table below lists the common difficulties experienced with vane pumps and hydraulic systems. It indicates, possible causes and remedies for each of the problems listed. S0708470K Page 7 Steering and Brake Pump (Denison T67DB Series) Problem Possible Cause Remedy Excessive noise in pump. Low oil level in reservoir. Fill reservoir to proper level with recommended fluid. Air in system. Open reservoir cap and operate system until purged. Bleed hydraulic lines at highest point down stream of pump while system is under pressure. Vacuum condition. Check inlet (suction) line and fittings for air leaks. Oil too thick.
Be certain correct type of oil is used in system. Warm up pump in cold weather until noise disappears. Damaged or missing pump seals at mating surfaces. Locate and replace damaged or missing seals. Cartridge kit not assembled properly. Reassemble cartridge kit. Pump inlet/outlet lines reversed. Reconnect lines to proper port connections. Pump overheating. Internal leakage. If excessive internal leakage exists, return to shop for complete overhaul. Heat exchanger not functioning. Locate trouble and repair or replace. System not developing pressure. Relief valve open. Repair or replace. Loss of fluid internally (slippage). Return to shop for evaluation and repair.
Cartridge kit not assembled properly. Reassemble kit. Cartridge kit assembled for opposite rotation. Reassemble kit to proper rotation. Pump inlet/outlet lines reversed. Reconnect lines to proper port connections. Disconnected or broken drive mechanism. Locate and repair. Loss of fluid. Ruptured hydraulic lines. Locate and repair. Leaking or missing seals. Locate and repair.