Komatsu — 10.1.4 Parts names and disassembly procedure

10. Alternator Disassembly Procedures 1) Through bolt M5 Remove the M5 through bolt. Increase the temperature at the center of the rear cover by about 20°C using a soldering iron, in- sert two flat-head screwdrivers between the front cover and the stator core and separate the assembly into the front side (front cover and rotor) and the rear side (rear cover and stator). Note: Be careful not to damage the sta- tor coil with the edges of the Fig. 1 screwdrivers. 2) Pulley nut 3) Pulley assembly 4) Rotor Fix the rotor in a vice and remove the Ml5 (22 mm) pulley nut to separate the pulley, front cover and rotor. % Dimensions shown in ( ) indicate the spanner sizes to be used.

5) Screw M4 6) Bearing retainer 7) Ball bearing 8) Front cover Remove the M5 screw securing the bear- ing retainer to separate the bearing re- tainer, ball bearing and front cover. Fig. 3 9) Nuts M5 and M6 10) Rear cover 11) Lead wire assembly Remove the M5 and M6 nuts securing the diode and IC regulator. Press in the grom- met and lead wire of the lead wire assem- bly into the hole in the rear cover to sepa- rate the stay and rear cover. Fig. 4 1 o-5