3. Inspection and Adiustement (3) Nozzle valve sliding test Wash the nozzle valve in clean fuel oil. Place the nozzle body vertically and insert the nozzle into the body to about l/3 of its length. The valve is normal if it smoothly falls by its own weight into the body. In peel, and immerse it in clean diesel oil or case of a new nozzle, remove the seal the like to clean the inner and outer sur- faces and to thoroughly remove rust-pre- ventive oil before using the nozzle. Note that a new nozzle is coated with rust-pre- ventive oil and is pasted with the seal peel to shut off outer air.
Nozzle valve sliding check by gravity (4) Nozzle punch mark r Y DLL A - 150 P 244J0 v_- T-T 1 L (Design code Size : size P lnjdon angle : size S L Nozzle insertion angle Code A: angled No code: no angle Type: DLL (semi-long type) YANMAR Punch mark 3-7