Komatsu — (5) Parts inspection and measurement

4. Engine Body Point 7 Oil seal Reassemble: l Replace the oil seal with a new one whenever disassembled. Apply lithium grease at the time of assembly. (5) Parts inspection and measurement (5.1) Cylinder block Especially clean head surface, cylinder bores and oil holes, and check after removing any carbon deposit and bonding agent. Appearance inspection crack. If crack is suspected, perform Check if there is any discoloration or Cylinder color check. Sufficiently clean the oil holes and check they are not clogged. Cylinder bore and distortion Measure at 20 mm below the crest of the liner, at 20 mm from the bottom end and at the center. Roundness:

Maximum value of the difference between the measured values in the same cross section. Cylindricity: Maximum value of the difference between the measured values in the same direction. Cylinder bore measurement positions Standard Limit Cylinder inside 4TNE94 94.000-94.030 94.130 diameter mm 4TNE98 98.000-98.030 98.130 4TNEi 06 (T) 106.000-l 06.030 106.130 Cylinder bore Roundness mm 0.01 or less 0.03 Cylindricity mm 4-21