4. Engine Body (5.5) Connecting rod Appearance inspection Inspect the portion near the boundary of the chamfered portion and I-beam section of the big and small ends of the connecting rod as well as the portion near the oil hole of the bushing at the small end for cracks, deformation, and discoloration. Twist and parallelism measurement Use a connecting rod aligner and mea- sure the twist and bend. Twist and Darallelism measurement 1 @ Rod small end measurement Measure the pin outside diameter ac- cording to (5.4)@ described above. Connecting rod - ahgner I (mm) Standard Limit 4TN E94=98 Twist measuiement using a connecting rod aligner bushing 30.025-30.038 30.068 Piston pin I.D. Pin O.D.
29.987-30.000 29.959 Clearance 0.025-0.051 0.109 4TNE106 (T) Piston pin I.D. bushing 37.025-37.038 37.068 Pin O.D. 36.989-37.000 36.961 Clearance 0.025-0.049 0.107 If the bushing is to be replaced because the oil clearance exceeds the limit, use spare part. 11 Connecting rod small end 0 Rod big end measurement Measure the crankpin and bushing ac- cording to (5.2)@ described above. 4-28