Komatsu — (5) Servicing points

7. Fuel injection System/Governor Point 3 Disassemble: l Governor housing removal (See 7.5(l) governor components.) 4 To remove the flyweight from the camshaft, first use the special wrench (1579150100) and remove the camshaft nut and spring washer. Then, screw the extractor (157926- 51 10) into the flyweight holder threaded por- tion and remove the flyweight assy. W To remove the governor housing from the in- Governor housing jection pump housing, insert the tappet holder (157931-2500) first between the tappet adjusting bolt and nut in the pump housing to disconnect the camshaft and tappet. Then remove seven bolts fastening the governor housing.

Remove the governor housing by tapping it with a wooden or plastic hammer. Reassemble: l Flyweight mounting nut tightening torque: 53.9-63.7 Nm (5.5-6.5 kgf-m) l Coat sealant (code No. 977770-01212) on the mating faces of the governor housing and pump housing. Point 4 Disassemble-Reassemble: l Remove the bottom screw by using a socket wrench handle. Point 5 Disassemble: l To separate between the tappet and the cam, place the cam at the TDC and insert the special service tool (tappet holder) into the hole in the tappet. (Zexel’s code No. 157931-2500) Point 6 Disassemble: l When removing the bearing cover, wrap oil seal protecting tape on the key groove and thread.

Take this action also at the time of assembly. l Tap the camshaft from the opposite side. l Insert a screwdriver into the gap and pry for removal. 7-4