OPERATION OPERATION Important: Before starting the engine, carefully read all operating instructions in this manual and do all the recommended pretrip inspections and daily maintenance. Check the engine oil and fuel levels, and drain contaminants from the fuel/water separator (optional). the engine overheats, uses excessive fuel or lubricating oil, vibrates, misfires, makes unusual noises, or shows an unusual loss of power, turn the engine off as soon as possible and determine the cause of the problem. Engine damage may be avoided by a quick response to early indications of problems. Before Starting the Engine When starting the engine in cold weather, refer to the Service Products” section.
Checking the Batteries NOTE: If you drain the fuel/water separator completely, you may have to prime the fuel system. Use only batteries that have been correctly filled and serviced. To provide corrosion protection, apply dielectric grease, part number 48-02349-000, liberally to the terminal pads. Approved suppliers are listed in Table 1. Be sure you are familiar with all of the instruments, gauges and controls which are needed to operate the engine. Note especially the location and function of the following:
Oil pressure gauge Low oil pressure warning light Coolant temperature gauge High coolant temperature warning light Water in fuel warning light Tachometer Table 1 Approved Electrical Lubricants Air restriction indicator Watch for any signs of engine problems when starting or driving. If 22 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION Manufacturer Lubricant or Part Number Shell Oil Co. No. 71032; No. 71306 Texaco, Inc. No. 955 Quaker State No. NYK-77