MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE NOTICE: For safety reasons, add the kerosene to the diesel only in the fuel tank. Add the kerosene first, then the diesel. Run the engine for a short time to allow the mixture to reach all parts of the fuel system. Engine Oils The engine is delivered from the factory filled with an approved engine oil. Figure 16 API Lubricant Service Mark When maintenance work is performed, record engine oil changes including details of the brand used, the quality category, and the Society of Automotive Engineers (SAE) viscosity rating of the oil. When topping off, use only engine oils of the correct API designation and SAE rating. NOTICE:

The use of non-approved engine oils could affect warranty rights, and cause engine damage. Only multigrade oils of American Petroleum Institute (API) service designation CI-4 will achieve proper performance for the cooled EGR engines. Look for the service mark printed on the oil container. See Figure 16. For information about oil in cold weather operation, see the heading "Low-Viscosity Engine Oil" later in this chapter. Synthetic Oils Synthetic oil may be used in MBE 4000 engines, provided they are of the correct API designation and viscosity, as required for non-synthetic oil. All information subject to change without notice. (Rev.

04/08) 49 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION